Tips on Replacing the Carpet in Your Pontoon Boat

Are you in the process of replacing the carpet onto flatten. Once the new carpet is ready to install,
your used pontoon boat? If so here are a fewto back half the carpet and glue the new carpet
helpful tips for doing the work yourself. Oneand the floor of boat. I recommend using marine
customer recently asked me, he was thinking ofgrade contact cement spray. It allows you would
replacing his pontoon carpet with indoor/outdoora couple of minutes to maneuver the carpet into
carpet tiles and whether or not could they beplace working out any lumps in the carpet. I
used on boats?prefer to glue at a temperature higher than 50
I informed him I would not recommend using thedegrees and make sure you use a good new
carpet tiles as they will come up on the cornershook knife or carpet knife.
after time from the sun and water. I alwaysNow proceed into doing the same steps with the
recommend using one solid piece of indoorremaining section of pontoon boat floor and
-outdoor carpet or marine grade carpeting.carpet. You may want to have another person
Remove all the pontoon boat furniture includinghelp you with the installation as a second set of
steering console and floor trim until you are downhands is not a bad thing. Now is a good time to
to the plywood. Now you can remove any of thego for lunch as you need to allow the carpet to
carpet that maybe stuck to the plywood as wellsettle a bit before next step.
as any of the old adhesive that was left behind.Next step is to cut off any overhanging sections
You may need to do little sanding to you getof the carpet and install floor trim. Now you can
down to a fresh clean surface. Now is a goodreinstall your pontoon boat furniture and steering
time to inspect any plywood that may needconsole. Installing pontoon boat carpeting is really
repaired or replaced.not big project to do yourself, especially if you
Next step is to roll out the new carpet on theenlist some help.
pontoon boat and allow some time to allow carpet